Volume 8 Issue 3-4 (2016)
Journal of Machining and Forming Technologies

$175.00$262.50

Editor-in-Chief: J. Paulo Davim (University of Aveiro, Department of Mechanical Engineering, Campus Santiago, Aveiro, Portugal)
ISSN: 1947-4369
Frequency: Quarterly
Print Format: 7″ x 10″, Softcover, Single column

ISBN: N/A Categories: ,

Table of Contents

Surface Topology and Analysis of MRR and SR for EN-31 in WEDM Using Grey Relational Theory
Yogesh Kumar Sharma, Neeraj Sharma, Rahul Dev Gupta, and Rajesh Khanna

Experimental Investigations to Study the Influence of CuO Nanoparticle-Blended Lubricant on Surface Finish in Turning of AISI 1040 Steel and Aluminum
G.V.S.S. Sharma, C.L.V.R.S.V. Prasad, S.V. Ramana, and P.N.L. Pavani

Artificial Neural Network Model and Genetic Algorithm-Based Optimization during Electric Discharge Machining of Alpha – Beta Brass
S. Marichamy, M. Saravanan, M. Ravichandran, S. Nagarajan, and G. Veerappan

Chemical-Assisted Mixed Abrasive Slurry Influence on Machining Physiognomies of Polycarbonate Bullet Proof Glass and Acrylic Heat-Resistant Glass in Ultrasonic Machining
Kanwal Jeet Singh, Inderpreet Singh Ahuja, and Jatinder Kapoor

Taguchi Method for Optimization of Material Removal Rate in USM of Polycarbonate Bullet Proof Glass and Acrylic Heat-Resistant Glass
Kanwal Jeet Singh, Inderpreet Singh Ahuja, and Jatinder Kapoor

Publish with Nova Science Publishers

We publish over 800 titles annually by leading researchers from around the world. Submit a Book Proposal Now!