Table of Contents
Simulation of High Speed Hard Turning Using the Finite Element Method
A.G. Mamalis, A.P. Markopoulos and J. Kundrák
Fuzzy Selection of Milling Tool Diameters and Strategies for Dies with Sculptured Surfaces
Titos Giannakakis, Virginia Lipari, George-Christopher Vosniakos
Modeling of the Effect of Tool and Cutting Parameters on the Dynamic Behaviour of a Thin Walled Workpiece in Peripheral Milling Process
Kamel Mehdi, Thabet Mezni and Jean-François Rigal
Effect of Non-Electrical and Gap Control Parameters in the Micro-EDM of WC-C
M.P. Jahan, Y.S. Wong and M. Rahman
Effects of Process Parameters on Performance Characteristics in Sink EDM
M.S. Sohani, V.N. Gaitonde, B. Siddeswarappa and A.S. Deshpande
Micro Machining of Electrically Non-Conductive Al2O3 Ceramic
Alakesh Manna, and Kanwaljit Khas
Some Investigations on Combined Effects of Reinforcement Percent and Process Parameters in Electro-Discharge Machining of Ceramic Particulate Composites
N.G. Patil, and P.K. Brahmankar
Manufacturing of Herringbone-Grooved Journal Bearing by Chemical Milling
T. K. Nandi
Design of Gravity Die Casting Process Parameters of Al-Si-Mg Alloys
A. Chennakesava Reddy, and Ch. Rajanna